I`m currently developing software on a TMS570LC4357-EP board and am trying to run the SCM self-test (per TRM section 3.3.2). I am running the code to start the test early in the execution, right after ...

This is Nojiam from Liton JPN. First, we would like to verfiy your refernce hybrid inverter shown on the link below and modify the codes for our tests so we would like ask you to provide soruce codes ...

Hello! As it says in the title I've been trying to make an active Sodium-Ion ESP32 active battery balancer using the UCC27282-Q1 for the past couple of months. I came up with 2 different versions, ...

I would like to ask about VSYS output. When the battery is not connected to the charger The waveform when a load of 1A is applied is shown below. CE pin is low. The voltage drops to VSYS=0V at 1A load ...

I wondered which parameters I can change (except parameters of my motor) during my own tuning process when using hvkit with F28069M ISO Control Card? When I was ...

I am working on a POL module that can do 12V-1V (and other standard POL output voltages). I like the design in LM27403EVM-POL600 and also the one in this app note that uses LM27402 and csd86350q5d: ...

We monitor PSU 12V at MON10, And we control LDO 1.1 V ENA by GPIO13. Now, we want to disable 1.1V LDO when 12V is failing to 10V. But we found the result is unexpected. Please help to check. The ...

XCP is a common requirement from automotive OEMs. I’ve found that Implementing XCP-on-CAN for a C2000 device is far from straightforward and there doesn’t seem to be much information publicly ...

I am working with the TIDEP-01032 example from the AM243x Motor Control SDK 09.02.00 and don't understand how the EtherCAT Firmware is loaded onto the PRU-ICSSG. In the EtherCAT Slave Simple Demo, ...

I am calculating the power consumption of all components on my circuit for thermal simulation. The circuit is the same as typical application circuit in the datasheet below and all FETs are ...

Yes, we can transfer the data like indicated but not sure this is the most optimal option. Can you please explain what you are trying to do? On the camera side what serializer are you going to use?

The two technologies are not compatible. Is there any reason an FPDlink SER cannot be used? I can provided compatible device to the ADI MAX96724/F/R.