Hello! As it says in the title I've been trying to make an active Sodium-Ion ESP32 active battery balancer using the UCC27282-Q1 for the past couple of months. I came up with 2 different versions, ...

I would like to ask about VSYS output. When the battery is not connected to the charger The waveform when a load of 1A is applied is shown below. CE pin is low. The voltage drops to VSYS=0V at 1A load ...

I am working on a POL module that can do 12V-1V (and other standard POL output voltages). I like the design in LM27403EVM-POL600 and also the one in this app note that uses LM27402 and csd86350q5d: ...

I wondered which parameters I can change (except parameters of my motor) during my own tuning process when using hvkit with F28069M ISO Control Card? When I was ...

XCP is a common requirement from automotive OEMs. I’ve found that Implementing XCP-on-CAN for a C2000 device is far from straightforward and there doesn’t seem to be much information publicly ...

May I know the fault response for all faults? Could you please confirm? (1) OCL: I think it is auto retry (2) UVP: I think it is auto retry (3) Negative OCL: I think it is auto retry (4) OVP: I think ...

The two technologies are not compatible. Is there any reason an FPDlink SER cannot be used? I can provided compatible device to the ADI MAX96724/F/R.

The value of Rfilter is 100 ohms, 0.1% tolerance, for each resistor <- while this value is 10x the recommended value, I suspect it does not have a great impact on our operation, your feedback would be ...