Can anyone give me a tip on how to receive SCI data with dynamic length (can range from 1 byte to over 16 bytes)? Polling the FIFO is not an option as the SCI communication is part of larger timing ...

The two technologies are not compatible. Is there any reason an FPDlink SER cannot be used? I can provided compatible device to the ADI MAX96724/F/R.

I am trying to calculate losses for the synchronous MOSFET. In table 2-2, the body diode conduction loss uses a term of (Vload*Fsw)/2. This results in a very high calculated loss. I think the voltage ...

I used board that named LAUNCHXL_F2800157. I use the example document to develop SCI bootloader, the document link is : https://www.ti.com/cn/lit/an/zhcadf7/zhcadf7 ...

Even though I enabled this configuration in Theia,I am not able to observe the energy trace in debug mode It appears that the configurations is showing as disabled. Could you please help me with this ...

MCAL is part of secure software and even i don't have admin rights to it. I am aligning with internal team on how to provide access, and i will try to provide my updates as soon as possible.

Now I can start the user program using the ethernet bootloader. The start address of the user program (LED_Blinky_RM57_At_0x20020) is 0x20020. The content in the current user program HL_sys_link.cmd ...

We are using F280049C for control of single phase PFC rectifier. This is a conventional topology consisting of bridge rectifier followed by single switch boost converter. The hardware and firmware are ...

Our software logic is such that: 1.we will first save the values of the IFIB Data Storage as default values. 2.After the voltage and current calibration operation is performed on the production line, ...

I would like to ask you some questions about SOH≠100%. Gas Gauge/SOH/SOH Load Rate is 0.5 and Design capcaity is 120mAh, we use 60mA to charge and 24mA to discharge in servel cycles, but SOH≠100%，It ...

I have purchased the F28379D R1_3 control card and TMDSHSECDOCK docking station and downloaded CCS 12.8.0.00012. I have connected the control card (AJ1) to my PC through the USB cable that comes with ...

I need to write data values on the SDs card txt file using the cc2640R2 example but there aren't any examples like fatsd in(cc2652) for the cc2640R2. Are there any example files for this issue?